Investigation on Interaction of Explosively Formed Projectile with Multi-layer Medium Targets

C Wang, W Xu, Y Bi

Abstract


To investigate the influence of liner material, charge diameter and standoff on explosively formed projectile (EFP) penetrating into multi-layer targets, a large number of experiments were performed and the experimental data on crater diameter, hole diameter, crater depth and penetration depth were obtained. Meanwhile, the numerical simulation have been done to study the formation and penetration processes of all the EFP with AUTODYN software. The numerical results of penetration depth are in good agreement with the experimental ones. The results indicate that the optimal liner material of EFP to achieve a larger penetration hole diameter and depth are aluminum and copper, respectively.


Full Text:

PDF

References


Wen, H. M. and Y. Yang, A note on the deep penetration of projectiles into concrete. International Journal of Impact Engineering, 2014, 66: 1-4. Crossref

Drathi, R., Das, A. J. M. and A. Rangarajan, Meshfree simulation of concrete structures and impact loading. International Journal of Impact Engineering, 2016, 91: 194-199. Crossref

Wu, H., et al., Hard projectile perforation on the monolithic and segmented RC panels with a rear steel liner. International Journal of Impact Engineering, 2015, 76: 232-250. Crossref

Nia, A. A., et al., Analysis of resistance of concrete target against penetration of eroding long rod projectile regarding flow field around the projectile tip. International Journal of Impact Engineering, 2013, 57: 36-42. Crossref

Smith, J., et al., Discrete modeling of ultra-high-performance concrete with application to projectile penetration. International Journal of Impact Engineering, 2014, 65: 13-32. Crossref

Guo, L., et al., Study mass loss at microscopic scale for a projectile penetration into concrete. International Journal of Impact Engineering, 2014, 72: 17-25. Crossref

Warren, T. L., Forrestal, M. J. and P. W. Randles, Evaluation of large amplitude deceleration data from projectile penetration into concrete targets. Experimental Mechanics, 2014, 54(2): 241-253. Crossref

Sherburn, J. A., et al., Meshfree modeling of concrete slab perforation using a reproducing kernel particle impact and penetration formulation. International Journal of Impact Engineering, 2015, 86: 96-110. Crossref

Wang, C., Wang, W. J. and J. G. Ning, Investigation on shaped charge penetrating into concrete targets. Chinese Journal of Theoretical and Applied Mechanics, 2015, 47(4):672-686. Crossref

Bian, H., et al., Numerical study of a concrete target under the penetration of rigid projectile using an elastoplastic damage model. Engineering Structures, 2016, 111: 525-537. Crossref

Feng, J., et al., An armour-piercing projectile penetration in a double-layered target of ultra-high-performance fiber reinforced concrete and armour steel: Experimental and numerical analyses. Materials and Design, 2016, 102: 131-141. Crossref

Yu, R., Spiesz, P., and H. J. H. Brouwers, Energy absorption capacity of a sustainable Ultra-High Performance Fibre Reinforced Concrete (UHPFRC) in quasi-static mode and under high velocity projectile impact. Cement and Concrete Composites, 2016, 68: 109-122. Crossref

Zeng, B. Q., et al., 3D numerical simulation of oblique penetration of antirunway penetrator to multilayer runway target. ACTA ARMAMENTARII, 2007 28(12): 1433-1437. [14] Xiao, J. G., et al., Demolition Mechanism and Behavior of Shaped Charge with Reactive Liner. Propellants, Explosives, Pyrotechnics, 2016. Crossref




DOI: http://dx.doi.org/10.21152/1750-9548.11.3.277

Copyright (c) 2017 C Wang, W Xu, Y Bi

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.